RIDGID® 76912, CT400 Crimp Press Tool with 6 Jaws, 7200 lb Ram, 120 V

The CT400 Press Tool, when used with appropriate jaw sets, is designed to mechanically press fittings onto tubing to create a water-tight and permanent seal. When the switch on the CT400 is depressed, an internal electric motor powers a hydraulic pump which forces fluid into the cylinder of the tool, forcing the ram forward and applying thousands of pounds of pressing force onto specially designed press fittings. The entire cycle duration is approximately four (4) seconds. Once the cycle begins to deform a fitting, it will automatically continue until completion. A hydraulic release button is provided to allow the removal of the jaw set or press ring from the tubing in the event of a power or system failure during pressing.